Contenu
The oil pressure sensor on a Chevrolet 4.3L V6 engine is part of a network of sensors that provides the powertrain control module (PCM) with information about the engine. This sensor measures the pressure of the engine oil and relays this data to the PCM. When the PCM detects low oil pressure it illuminates the oil pressure light. As time passes, the oil pressure sensor may develop an oil leak or begin providing the PCM with inaccurate pressure information, necessitating its replacement. New oil pressure sensors can be purchased from automotive parts stores and Chevrolet dealerships.
Step 1
Locate the oil pressure sensor. It is on the right side of the engine, just below the intake manifold. It is approximately 3-inches long and is made from black plastic. A two-wire electrical connector is attached to the end of the sensor.
Step 2
Clean any residual oil off of the sensor and start the engine. Watch the sensor to see if any oil leaks out. If oil seeps out of the sensor at any point, then the sensor is faulty.
Step 3
Turn off the engine and disconnect the oil pressure sensors electrical connector and remove the sensor from the engine using a 1-inch box-end wrench. (https://itstillruns.com/install-oil-pressure-gauge-6547614.html) into the oil pressure sensor hole on the engine block.
Start the engine and watch the gauge. It should read at least 6 psi at 1000 rpm. If the oil pressure meets or exceeds this specification but the oil pressure light is on, then the sensor is faulty and must be replaced.
Tip
- Oil pressure gauges are designed to measure the oil pressure inside an engine. They are available from auto parts stores and automotive tool retailers.
Items you will need
- 1-inch box-end wrench
- Oil pressure gauge
