Contenu
Squeezing 700 horsepower out of Chevrolets popular small block engine platform is a task which has been accomplished numerous times through the years since the small block V8 engine was introduced. It remains a difficult and expensive task.
Step 1
Machine the engine block so that it increases compression in the cylinders to match the compression needs of the aluminum race heads, supercharger, and nitrous injection. A stock Chevrolet 350 block can be machined to these tolerances with only minor danger of critical engine failure.
Step 2
Install a bottom end crankshaft which will allow the engine to displace 383 cubic inches rather than 350. Be certain to use a high performance crankshaft matched with the correct lightweight pistons and rods. Stock components will not work under the demands of a 700 horsepower engine build.
Step 3
Install the aluminum race heads onto the block, followed by the roots-type supercharger. The supercharger can be either fuel injected or carbureted, depending on your preference.
Step 4
Install the air-to-water intercooler in front of the vehicles radiator.
Install the nitrous injection system. With the setup outlined, the injectors should be no larger than 150 horsepower jets in order to prevent critical engine damage. Larger power gains are possible only by replacing the engine block with a structurally reinforced lightweight racing block.
Tip
- Follow the guidance of a professional engine builder while setting up your race engine. If possible, contract the work to a recognized professional to avoid potential problems later on.
Items you will need
- Roots-type twin screw supercharger
- Ported aluminum race cylinder heads
- High performance crankshaft
- Lightweight race-type pistons and rods
- Air-to-water intercooler
- Nitrous oxide injection system
