Contenu
- Removing the Door Panel
- Step 1
- Step 2
- Step 3
- Step 4
- Removing the Glass
- Step 1
- Step 2
- Step 3
- Step 4
- Items you will need
If the window glass in your Toyota Corollas driver side door is even slightly cracked or damaged, you need to replace it immediately. A cracked window becomes more fragile and has a higher risk of shattering; this poses a greater danger for the drivers side door. In order to remove and replace the window glass, you need to get inside the door by removing the inner trim panel.
Removing the Door Panel
Step 1
Disconnect the negative cable from the Corollas battery. This is needed if the door uses any electronics; since you are dealing with the drivers side door, this is very likely.
Step 2
Disconnect the window controls from the door. For power controls, pry the control switch up with a trim stick and disconnect its electrical connector. For a window crank, insert a rag behind the handle and rub it back and forth to disengage the handles clip.
Step 3
Detach the trim cover for the doors mirror by unscrewing and removing the control handle and prying the covers retainers loose with a screwdriver.
Step 4
Pry off the trim panels covering the door panels mounting screws with the trim stick and remove the screws; this includes the door handles trim piece and the armrest panel.
Insert the trim tool behind the doors trim panel and work it around the outer edge to disengage the clips. You can now pull the panel up and off the door and disconnect all electrical connectors behind it.
Removing the Glass
Step 1
Peel back the plastic watershield covering the door and remove the black plate covering the hole in the door by removing its screws. Pry the weatherstripping out of the top of the door.
Step 2
Remove the mounting bolts attaching the window glass to the window regulator. These bolts should require a hex wrench.
Step 3
Pull the glass up and out of the door. Use caution if the glass is damaged in any way.
Step 4
Lower the replacement glass down into the door. Make sure it is correctly placed within the regulator and secure it with the mounting bolts.
Reconnect all parts and trim panels in the reverse order that you removed them.
Items you will need
- Screwdriver
- Trim stick
- Cloth rag
- Hex wrench
- Window glass
