Contenu
If you need to make repairs on your Jet Ski, it is a good idea to drain the fuel tank before you begin. You dont want leaking fuel or accidental starts while youre working. Unfortunately, most personal watercraft, such as Jet Skis and Sea-Doos, do not include a plug for draining the tank easily. You can begin siphoning by sucking one end of a hose. But its much safer to use a manual siphon pump.
Step 1
Turn off the motor, remove the key and let the craft sit long enough that the engine and the tank cool down. Siphoning hot fuel could be dangerous and cause burns.
Step 2
Attach a hose and hose connector to both ends of the pump. Tighten the connector securely.
Step 3
Open the fuel cap on the personal watercraft and insert the intake hose until the end is submerged. The intake hose is usually near the hand pump.
Step 4
Set the empty fuel container on the floor. Position it so that it is lower than the crafts fuel tank. This will allow gravity to pull the fuel into the container.
Step 5
Place the discharge hose into the empty fuel container.
Hold the pump mechanism with one hand while you pull out the pump handle. Push it back in three or four times to start the gas flowing. At this point, you will no longer need to keep pumping.
Tip
- Rinse out the siphon pump when you are finished before storing it.
Warnings
- Use the pump only in a well-ventilated area, as gas fumes can be harmful to your health.
- Use only an empty container approved for use with gasoline.
Items you will need
- Siphon pump
- Empty fuel container
