Contenu
If you are relying on your high-beams more often than usual or have motorists flashing their lights at you even though you do not have your high-beams on, you may need to adjust the headlamps on your Chrysler. Your Chryslers headlamps provide you the light you need to see safely during nighttime driving. If your headlamps are incorrectly adjusted, the pattern they project can be inadequate and can also blind oncoming drivers. Periodically verifying and adjusting the aim of your Chryslers headlamps will give the the ideal nighttime visibility.
Step 1
Find a flat surface that is adjacent to a large wall. You will need a level surface that extends at least 30-feet from the wall. Pull your vehicle close the the wall as straight as possible.
Step 2
Mark the center line of your Chrysler on the wall using the masking tape. Coolbulbs.com recommends using a yardstick placed on the hood ornament and extended to the wall to get a precise mark. Measure the center of one headlight from the ground and from the center of one headlight to the center of the vehicle. Using more tape, transfer these measurements to the wall to mark the horizontal and vertical center lines of each headlamp beam.
Step 3
Measure 25-feet away from the wall and park the Chrysler there. Be sure to keep the vehicle perpendicular to the wall, if the vehicle is crooked it will skew the adjustments.
Step 4
The adjustment screws on Chryslers are located on top of the headlight assembly. Locate these screws and determine which screws control the vertical headlamp movement and which adjust the horizontal aim. You will most likely only need to adjust the vertical alignment of your Chryslers headlamps. Several manufacturers do not recommend adjusting the horizontal headlamp aim.
Adjust the headlamp beams until they are two inches below the horizontal lines and two inches to the right of the vertical lines by turning the adjustment screws. Adjust each plane separately for the greatest accuracy. In this position your Chrysler headlamps will project the most efficient beam pattern without blinding other drivers.
Tips
- Some Chrysler models feature a bubble level that is located on top of the headlamp assembly. Chrysler states that the headlamps are properly aimed when the bubble level is reading zero, however this level can lose calibration over time.
- Aiming your low-beam headlamps also aims your high-beams at the same time. The aiming may not line up exactly but always defer to properly aimed low-beam headlamps.
Warning
- Aiming your Chryslers headlamps high can severely hamper the safety of other motorists.
Items you will need
- Tape
- Phillips screwdriver
